 |
Interconnect Boards & Cables |
|
| |
| CON_1x1 |
|
Data Sheet |
|
| Connects all signals in one connector adjacent in the vertical direction. The primary use is for connecting signals between boards in some connectors only, while leaving others unconnected. |
|
 |
|
|
| CON_1x2 |
|
Data Sheet |
|
| Connects all signals in two connectors adjacent along the connectors. The primary use is for adding connections between FPGAS. |
|
 |
|
|
| CON_2x1 |
|
Data Sheet |
|
| Connects all signals in two connectors adjacent in the transversal direction. The primary use is for adding connections between FPGAS. |
|
 |
|
|
| CON_2x2 |
|
Data Sheet |
|
| Adds a bus that connects 4 adjacent connectors. By removing 0-ohm resistors the bus can be split in two diagonal buses. The primary use is for adding diagonal connections between FPGAs on the HAPS board, or for creating a global 4-FPGA bus. It’s typically placed on the 4 middle connectors on HAPS. |
|
 |
|
|
| CON_CABLE40 |
|
Data Sheet |
|
| Connects all signals and GND in two non-adjacent connectors by a ribbon coax cable that retains signal integrity and allows high speed signaling. The primary use is for adding connections between FPGAs, or attaching high speed signals to I/O subsystems not mounted on a daughter board. |
|
 |
|
|
| CON_CABLEX40 |
|
Data Sheet |
|
| Extension cable that works like CON_CABLE but also connects power which allows you to connect remote daughter boards, e.g. the front panel board CTRL_1x2, to a HAPS motherboard. |
|
|
|
|
| CON_CABLE_RIO |
|
Data Sheet |
|
| Connects any 2 RIO connector pairs on HAPS-20 or FPGAPRO_2x3 boards. It has an on-board low-jitter LVDS oscillator. |
|
 |
|
|
| |
Products 